Filter
Top Products
Serial Commands Summary C–1
SERIAL COMMANDS SUMMARY
C
C.1 Configuration Commands
The following is a summary of configuration commands sent by the host system. More
details are provided in Section 4.4, Configuration Commands.
Note: These commands may contain port–specific data not relevant to the SCANTEAM 3700
machine mount CCD. This extra data will be accepted, but ignored. These items are
identified in the command descriptions by a pound sign (#).
Command Format
Set Communications Port Command <Ka baud, parity, stop bits, data bits>
Set Preamble Command <Kd enable, data>
Set Postamble Command <Ke enable, data>
Set Communications Protocol Command <Kf mode>
Set Trigger Mode Command <Kg mode_global, mode_port_1,
mode_port_2, #>
Set Read Timeout Command <Kh mode_global, time_global,
mode_port_1, time_port_1,
mode_port_2, time_port_2, #, #>
Set No Read Message Command <Kk enable, data>
Set Votes Command <Km data_global, data_port_1,
data_port_2, #>
Set Code 39 Command <Kp enable, require checksum, send
checksum, minimum length,
maximum length>
Set Codabar Command <Kq enable, send start/stop, minimum
length, maximum length>
Set I 2 of 5 Command <Kr enable, require checksum, send
checksum, minimum length,
maximum length>
Set UPC A/E, EAN 8/13 <Ks enable UPC, enable EAN>
Set Code 128 Command <Kt enable, minimum length,
maximum length>
Set Beeper Mode <Ku mode_global, mode_port_1,
mode_port_2, #>