Filter
Top Products
20 Chapter2
Configuring Network Connectivity Using SAM
Step 1: Configuring Network Connectivity
Internet Addresses window.
Proceed to step 5 if a gateway is not required for this remote
connection.
SAM displays fields for entering gateway information if a gateway
is required for this remote system connection. Use the SAM online
help system for information about gateways.
5. Activate the OK button to enable your system to communicate with
this system and return to the System-to-System Connectivity object
list.
SAM updates the object list to include the remote system you
configured.
NOTE You can modify or remove remote systems and modify default gateways
by highlighting the Remote System Name from the object list and
choosing Modify, Remove, or Modify Default Gateway from the “Actions”
menu.
6. Choose Exit from the “File” menu.
7. At the Networking Communications window, choose Exit SAM from
the “File” menu to leave SAM.
8. Verify remote system configuration.
a. View the list of remote systems you can communicate with using a
symbolic name by typing the following command at the HP-UX
prompt:
more /etc/hosts
b. View the configured destinations reached through gateways and
the gateways used to reach those destinations by typing the
following command at the HP-UX prompt:
netstat -r
To verify that you can communicate with a remote system via the
10/100Base-TX product, return to chapter 1, “Step 8: Verify the
Installation.”