Filter
Top Products
Appendix A 93
10/100Base-TX Interface Card Statistics
RFC 1213 MIB II
Operation Status The current operational state of the interface. This
value is the same as the hardware status displayed by
lanscan(1M). It will have one of the following values.
Last Change The value of SysUpTime at the time the interface
entered its current operational state. If the current
state was entered prior to the last reinitialization of the
local network management subsystem, then this object
contains a zero value.
Inbound Octets The total number of octets received on the interface,
including framing characters.
Inbound Unicast Packets The number of subnetwork-unicast packets
delivered to a high-layer protocol.
Inbound Non-Unicast Packets The number of non-unicast
(subnetwork-broadcast or subnetwork-multicast)
packets delivered to a higher-layer protocol.
Inbound Discards The number of inbound packets that were discarded
even though no errors had been detected, to prevent
their being delivered to a higher-layer protocol. One
possible reason for discarding such a packet could be to
free up buffer space.
Inbound Errors The number of inbound packets that contained errors
preventing them from being deliverable to a
higher-layer protocol.
Inbound Unknown Protocols The number of packets received via the
interface which were discarded because of an unknown
or unsupported protocol.
Outbound Octets The total number of octets transmitted out of the
interface, including framing characters.
Outbound Unicast Packets The total number of packets that
higher-level protocols requested be transmitted to a
subnetwork-unicast address, including those that were
discarded or not sent.
up(1) Ready to pass packets
down(2) Not operative (card is down)
testing(3) In test mode