Filter
Top Products
24 Chapter3
SCSI Parameter and Termination Information
Configuring SCSI Parameters
Configuring SCSI Parameters
In order to change the SCSI ID, the path for the card of interest must
first be determined. Once the path is known, the SCSI ID may be
changed. The example below lists the commands used to determine the
path for the card of interest, change the SCSI ID of the A5838A, and also
some of the other parameters of the card.
The machine should be booted to the BCH prompt before beginning this
procedure.
The path for the A5838A SCSI card is determined as follows:
- at the Main Menu, type "in" (for information menu)
- at the Information Menu, type "io" (to display I/O interface information)
The information displayed should be similar to the following:
PCI DEVICE INFORMATION
Path Vendor Device Bus Slot
Description (dec) Id Id # #
----------- ----- ---- ---- --- ---
.
.
SCSI bus cntlr 0/2/0/0 0x1000 0xb 16 6
.
.
.
The path for the card in this example is '0/2/0/0'.
Once the path for the card is known:
- type "main" (to return to main menu)
- type "ser" (to display service menu)
- type "scsi" (to display current status of SCSI devices)
The information displayed should be similar to the following: