Filter
Top Products
Switch cover
Description Spare part number
Switch cover (includes LED board and LED board cable) 454006-001
Before removing the switch cover, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 37).
5.
Remove the keyboard (see
Keyboard on page 47).
Remove the switch cover:
1.
Turn the computer upside down, with the rear panel toward you.
2.
Remove the following:
(1) Two rubber screw covers. The rubber screw covers are included in the Plastics Kit, spare part
number 454010-001.
(2) Three Phillips PM2.5×7.0 screws.
(3) Five Phillips PM2.0×3.0 screws.
3.
Turn the computer right-side up, with the front toward you.
4.
Open the computer as far as possible.
Component replacement procedures 49