HP (Hewlett-Packard) 3010 Personal Computer User Manual


 
Option Description
Onboard Serial Port 1 Allows you to select a setting for the onboard serial port:
Disabled
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
PCI Device SERR# Disables/enables SERR#.
Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3-4 Computer Setup—Boot
Option Description
F9 Boot Menu Disables/enables F9 Boot Menu.
F10 Setup Prompt Disables/enables the F10 Setup prompt message on the logo screen.
F11 Recovery Disables/enables F11 Recovery and provides the option of showing the F11 Recovery prompt
message on the logo screen. Choose from the following:
Disabled
Enabled no prompt
Enabled and prompt
F12 Boot from LAN
Prompt
Disables/enables the F12 Boot from LAN prompt message on the logo screen.
Hard Disk Boot Seq. Allows you to specify the order of attached hard drive devices (such as USB HDD storage or USB
flash media). The first drive in the order has priority in the boot sequence and is recognized as
drive C (if any devices are attached).
Optical Drive Boot
Seq.
Allows you to specify the order in which attached optical drives (including USB ODD) are checked
for a bootable operating system image.
Network Boot Seq. Allows you to specify the order in which network devices (including UP NIC cards) are checked for
a bootable operating system image.
First Boot Device
Second Boot Device
Third Boot Device
Fourth Boot Device
Allows you to specify which devices will boot first, second, third, and fourth or to disable any of the
four:
Removable
CDROM
Hard Disk
Network
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating
system has started.
Table 3-3 Computer Setup—Advanced (continued)
HP Pro 3000/3080 – Computer Setup (F10) Utility 17