Filter
Top Products
Removal and replacement procedures 29
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 27).
4. Disconnect all cables connected to the SAS/SATA backplane.
5. Remove all hard drives ("Hard drives" on page 27).
6. Remove all hard drive blanks ("Hard drive blanks" on page 28).
7. Remove the SAS/SATA backplane.
To replace the component, reverse the removal procedure.
Air baffle
To install the component:
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 25).