Filter
Top Products
Removal and replacement procedures 38
3. Remove the serial label pull tab by extending it out, and then pressing on the underside to release it
from the chassis.
4. Remove the access panel ("Access panel" on page 27).
5. Remove all hard drives ("Hard drives" on page 27).
6. Remove all hard drive blanks ("Hard drive blanks" on page 28).
7. Remove the media cage ("Media cage" on page 32).
8. Use the T-10 Torx screwdriver to loosen the two T-10 screws on each side of the front bezel. The T-
10/T-15 Torx screwdriver is located on the rear of the server.
9. Slide the bezel to the left, release the USB cover by gently lifting the plastic latch, and then detach
the bezel.
To replace the component, reverse the removal procedure.