HP (Hewlett-Packard) 6212 Network Router User Manual


 
34 May 2004 6212-A2-GB20-00
4.4.4 PPPoA
To set up PPPoA, click on PPPoA, then configure the common fields and the following fields.
Click on the Add button to add the entry.
User name and Password: Used for remote customers to login upon dialup. PPPoA is
manually activated by entering startup commands from the page: Advanced>Configure
PPPoA. The Authentication field defines the authentication code: PAP or CHAP.
Authentication: Defines the authentication code (PAP or CHAP).
4.4.5 MER
MAC Encapsulation Routing (MER) enables the ATU-R to route IP addresses on the RFC 1483
bridged link. NAPT function is supported to allow multiple private IP addresses on the LAN to
share a public IP address.
To set up MER service, configure the common fields, then enter the IP Address and Subnet
Mask under the MER section of the screen. Click on the Add button to add the entry.
4.5 LAN IP Address
The default LAN IP address is 192.168.1.1. Click on LAN Setup from the menu bar to
configure the LAN IP address. Type the IP address and subnet mask. Click on Apply to
submit the settings. When the new IP address is applied, the Web configuration will be
interrupted. Use the new IP address to login.