HP (Hewlett-Packard) 6212 Network Router User Manual


 
60 May 2004 6212-A2-GB20-00
5.9.2 Delete Encapsulation
To delete encapsulation, select a VCC entry and then click on the Delete Encap button.
5.9.3 Add a VCC
To add a VCC entry, complete the following steps.
STEP 1:
Click on the Add VCC button. The VCC screen appears.
STEP 2:
Enter values for the parameters (explained below).
STEP 3:
Click on the Apply button at the bottom of the page.
VPI Virtual Path Identifier (VPI) that identifies this ATM
connection. The valid range is 0 to 4095.
VCI Virtual Channel Identifier (VCI) that identifies this ATM
connection. The valid range is 0 to 65,535.
Peak Cell rate
(cells/sec)
Defines the fastest rate a user can send cells to the
network. It is expressed in cells per second.
Average Cell rate
(cells/sec)
Defines the maximum sustainable average rate a user can
send cells to the network. It is expressed in cells per
second. This specifies the bandwidth utilization. This value
must always be less than or equal to the Peak Cell Rate.
Burst size (cells) Maximum number of cells the user can send at the peak
rate in a burst, within a sustainable rate.
CDVT (cells) Constrains the number of cells the user can send to the
network at the maximum line rate.
Type Select data or voice