Filter
Top Products
Removal and replacement procedures 32
5.
Raise the levers, and lift the SPI board from the server.
6. Remove all components from the failed SPI board.
To replace the component, reverse the removal procedure.
SAS/SATA hard drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
1. Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations ("SAS
hard drive LED combinations" on page 85).
2. Back up all server data on the hard drive.
3. Remove the hard drive.
To replace the component, reverse the removal procedure.