Filter
Top Products
Removal and replacement procedures 63
To remove the component:
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 27).
3. Remove the access panel (on page 28).
4. If the existing cache module is connected to a capacitor pack, observe the FBWC module LEDs (on
page 88):
o If the amber LED is flashing, data is trapped in the cache. Restore system power, and then restart
this procedure from step 1.
o If the amber LED is not illuminated, remove the controller from the server, and then continue with
the next step.
5. Disconnect the cable.
6. Remove the SPI board (on page 31).
7. Open the cache slot latches.
8. Remove the cache module.
To replace the component, reverse the removal procedure.