Filter
Top Products
Displaying and Adjusting the Image 25
3. Press the PPower button again. The lamp turns off. When the
projector beeps twice (after about 3 seconds), you can unplug the
power cord.
(If the projector is mounted on the ceiling, you will need to wait
10 seconds for the projector to cool down before you can unplug
the power cord.)
If you want to turn the projector on again, make sure the orange
light is not flashing, then press the P
Power button.
4. If you extended the adjustable front foot, press up on the blue
foot release lever to retract it.
5. Replace the lens cap.
Using the Direct Power On Function
The Direct Power On function enables faster setup. The projector will
start up automatically when you plug it in; you won’t have to press the
P
Power button.
Follow these steps to enable Direct Power On:
1. Press the
Menu button on the remote control and select the
Extended menu.
2. Choose
Operation and press Enter.
3. Choose
Direct Power On and press Enter.
4. Highlight
On and press Enter.
5. Press
Esc or Menu to exit.
The setting will take effect the next time you plug in the projector.
caution
Turn the projector off when
not in use. Continuous
24-hour-a-day use may
reduce the projector’s
overall life.
note
If a power outage occurs
when Direct Power On is
enabled and the projector is
plugged in, the projector will
start when the power is
restored.
Montreal User's Guide.book Page 25 Tuesday, April 19, 2005 11:27 AM