Filter
Top Products
54 Fine-Tuning the Projector
The countdown for the elapsed time begins as soon as you close
the Password Protect menu. (You can check the elapsed time in
this menu next to
Time elapsed.)
10. To enable your screen logo, select
User’s Logo Protect and press
Enter. Select ON and press Enter.
When this feature is on, the logo appears whenever you turn on
the projector (if the
Startup Screen is enabled in the Extended
menu; see page 55). It also appears when you press the A/V Mute
button (if you selected the
Logo as the Background Color in the
Extended menu). None of the User’s Logo features in the
Extended menu can be changed when the User’s Logo Protect
function is enabled.
Starting the Projector with a Password
When the password function is enabled, you see this screen when you
plug in and turn on the projector:
Hold down the
Num button on the remote control and use the
numeric keypad to enter the four digit password.
The password screen closes, the numeric keypad is automatically
deactivated, and projection begins.
If the password is not correct, you see the message
Wrong password.
Please try again.
If you enter an incorrect password three times in
succession, you see the message
The projector’s operation will be
locked. Request code xxxxx
and the projector switches to standby
mode for approximately 5 minutes. Write down the request code.
Then disconnect the projector’s power cord from the electrical outlet,
reconnect it, and turn the projector back on.
Montreal User's Guide.book Page 54 Tuesday, April 19, 2005 11:27 AM