Filter
Top Products
Maintaining the Projector 63
4. Turn the projector over. Press in on the tabs and lift up the lamp
cover.
5. Loosen the two screws holding the lamp in place (you don’t need
to remove them).
6. Hold the lamp as shown and pull it straight out.
7. Gently insert the new lamp. (If it doesn’t fit easily, make sure it is
facing the right way.)
Loosen, but don’t
remove these screws
caution
The lamp in this product
contains mercury. Dispose of
it according to local, state, or
federal laws.
Montreal User's Guide.book Page 63 Tuesday, April 19, 2005 11:27 AM