Filter
Top Products
5.
Remove the upgrade bay device (4) from the computer.
6. If it is necessary to remove the hard drive from the upgrade bay cradle, position the upgrade bay
cradle with the front bezel toward you.
7. Loosen the Phillips PM2.5×10.0 captive screw (1) that secures the hard drive to the upgrade bay
cradle.
8.
Grasp the Mylar tab (2) on the hard drive and slide the hard drive (3) forward to disconnect it
from the upgrade bay cradle.
9. Remove the hard drive (4) from the upgrade bay cradle.
Reverse this procedure to install the upgrade bay device.
Component replacement procedures
61