Filter
Top Products
5.
Lift the right side of the keyboard shield (1) until it rests at an angle, and then remove the shield
(2) by lifting it straight up.
NOTE: The keyboard shield is included with the keyboard spare part kit.
6. Release the ZIF connector (1) to which the power button board cable is attached, and disconnect
the power button board cable from the system board.
7. Release the ZIF connector (2) to which the LED board cable is attached, and disconnect the LED
board cable from the system board.
8. Remove the switch cover by lifting it straight up (3).
Reverse this procedure to install the switch cover.
Component replacement procedures
75