Filter
Top Products
To load 10 x 15 cm (4 x 6 inch) photo paper in the photo tray
1. Raise the output tray until it goes no further.
2. Pull out the photo tray.
3. Insert the stack of photo paper into the photo tray with the short edge forward and
the glossy side down. Slide the stack of photo paper forward until it stops.
If the photo paper you are using has perforated tabs, load the photo paper so that
the tabs are closest to you.
4. Slide the paper-length and paper-width guides inward against the stack of photo
paper until the guides stop.
Do not overload the photo tray; make sure the stack of photo paper fits within the
photo tray and is no higher than the top of the paper-width guide.
5. Push in the photo tray, and then lower the output tray.
Avoid paper jams
To help avoid paper jams, follow these guidelines.
● Remove printed papers from the output tray frequently.
● Do not leave originals on the glass. If you load an original in the automatic document
feeder while there is already an original on the glass, the original can jam in the
automatic document feeder.
● Prevent curled or wrinkled paper by storing all unused paper flat in a resealable bag.
● Ensure that paper loaded in the input tray lays flat and the edges are not bent or
torn.
Chapter 4
60 HP Photosmart C6100 All-in-One series
Use the HP All-in-One features