Filter
Top Products
CAUTION Do not print cardstock, envelopes, heavy or extra heavy paper, or unsupported sizes
of media from the 500-sheet trays. Print on these types of media only from tray 1. Do not overfill
the input tray or open it while it is in use. Doing so can cause paper jams.
Load custom-size media into tray 2
To use custom media, change the size setting on the control panel to Custom and set the unit of
measure, X dimension, and Y dimension. See
Configure a tray to match print job settings for more
information.
1. Slide open the tray from the MFP.
2. Continue loading the print media as described in steps 2 through 4 of the “Load detectable
(standard-size) media into tray 2, 3, or 4” section. Then proceed to step 3 in this procedure.
3. Slide the tray into the MFP. The MFP control panel shows the tray type and size configuration. To
specify specific custom dimensions, or if the type is not correct, touch OK when the MFP prompts
to change the size or type.
4. If the configuration is correct, touch Exit.
ENWW Load paper and print media 97