Filter
Top Products
4. Remove one screw (callout 1), and then remove the Tray 1 pickup solenoid.
Figure 1-45 Remove the Tray 1 pickup solenoid (2 of 2)
1
Duplex solenoid
NOTE: This section applies to duplex models only.
1. Remove the following components:
●
Tray 2 cassette
●
Right cover. See
Right cover on page 12.
●
Left cover. See
Left cover on page 11.
●
Rear cover, rear door, and duplex-paper-feed assembly. See
Rear cover, rear door, and feed
assembly on page 20.
●
Top cover assembly. See
Top cover with touchscreen control-panel module on page 16 or
Top cover with LCD control-panel module on page 13.
●
Fan. See
Fan on page 39.
2. Open the toner cartridge door and the rear jam access door.
ENWW
Removal and replacement procedures
35