Filter
Top Products
15
Step 3: Set the configuration switches (UNIX systems
only)
Only read this section if you are installing your autoloader into a UNIX system. Go straight to
step 4 if you are installing your autoloader into a Windows PC.
1 Check the UNIX Configuration Guide on the HP StorageWorks Tape CD-ROM for specific
advice for your operating system.
The following table summarizes the typical switch settings for different types of server.
2 If your UNIX configuration requires it, change the configuration switches located on the
underside of the autoloader from the default settings shown in figure 5.
Switch Number
System Type 12345678
Default and most PC systems On On Off On On On On On
HP Tru64 v.5.0 systems On On Off On On On On On
HP Tru64 v.4.0 systems On On Off On On On On Off
HP OpenVMS systems
On On Off On On On On On
HP-UX systems On On Off On On On On On
IBM AIX systems On On Off On On On On On
Linux systems
On On Off On On On On On
Sun Solaris, version 2.7 and
higher
On On Off On On On On On
Sun Solaris, version 2.6 and
lower
On On Off Off On On Off Off
autoload_master-frame6.fm Page 15 Monday, December 29, 2003 9:39 AM