Filter
Top Products
43
Understanding the OAR LED
The amber Operator Attention Required LED indicates warning conditions, as described in the
following table:
LED display Meaning
On A serious hardware error has occurred.
• If you have just installed the autoloader, check the installation
for loose connections and repeat the self-test. One of the two
power cables may not be connected. (An autoloader requires
two power connections: one for the autoloader and one for
the robotics.) If this is the problem, the front panel message is
Coms Error.
• Run HP Library & Tape Tools to determine what the problem is.
• If the fault condition persists, write down the message
displayed on the front panel and call for service.
Fast flashing (four times per
second)
A firmware upgrade is taking place.
Medium flashing (twice per
second)
• The tape cartridge is wearing out and should be replaced.
The "Worn Media" message will be displayed in this case.
Copy any data you wish to keep onto a new cartridge and
discard the old cartridge.
• The tape heads need cleaning. The "Clean Me" message will
be displayed in this case.
Slow flashing
• The front panel door is open when it should not be. The "Close
Door" message will be displayed in this case.
• There is a cartridge in the autoloader, but no magazine is
present. The "Stray Tape" message will be displayed in this
case. Load an empty magazine to retrieve the cartridge.
• A hard fault condition has occurred. The message displayed
will give information about the type of error. Look up the
message in the electronic User’s Guide on the
HP StorageWorks Tape CD-ROM to determine what to do.
autoload_master-frame6.fm Page 43 Monday, December 29, 2003 9:39 AM