Filter
Top Products
41
Do drivers need to be installed and, if so, which ones
Testing after installation
Remember that the system recognizes devices during boot-up. If you swap or connect a
product when your system is running, you will need to reboot the system. Rebooting the system
will reset devices and will often resolve problems. It is good practice to reboot every time you
add a driver or install firmware.
Caution Never power off the drive during a firmware upgrade.
The server does not reboot after installation
Description Further information
It is unclear whether there is a need to
install drivers onto the system, and more
help is required.
Detailed information specific to your system can be
found on the www.hp.com/go/connect web site.
Windows drivers can be obtained from the
HP StorageWorks Tape CD-ROM or from
www.hp.com/support. For support on UNIX
systems, see the UNIX Configuration Guide on the
HP StorageWorks Tape CD-ROM.
(Backup software that states support for
HP StorageWorks DAT autoloaders also provides
the required drivers.)
The required drivers do not appear to be
available.
Future drivers will be provided via the support web
site when they become available.
Possible reason Recommended action
You have installed an additional SCSI host
bus adapter and its resources are clashing
with an existing adapter.
Remove the new host bus adapter and check the
server documentation.
You have disconnected the power or SCSI
cable from the server’s boot disk during the
drive installation process.
Check that the cables to all devices are firmly
connected.
autoload_master-frame6.fm Page 41 Monday, December 29, 2003 9:39 AM