Filter
Top Products
19
Step 5: Attach power cable
An external HP StorageWorks DAT autoloader will operate using any voltage in the range
100–240 volts (0.7 A, 50-60 Hz). No adjustment is needed. To connect your autoloader to
the power supply, proceed as follows:
1 Make sure that the autoloader is switched OFF. The power switch is on the rear panel.
2 Plug the power cable securely into the socket on the rear panel of the autoloader. (See figure 7.)
3 Plug the other end of the power cable into the power outlet.
autoload_master-frame6.fm Page 19 Monday, December 29, 2003 9:39 AM