Filter
Top Products
37
ẇ Get the banner paper ready for the printer:
■ From the stack of banner paper, tear off the number of sheets
you need to print the banner. (You must have at least five sheets
in the stack.)
■ Tear off the perforated strips, if there are any.
■ Fan the stack so that the pages don’t stick together in the printer.
Ẉ Put the paper in the IN drawer so that the unattached edge is at the top of the
stack. Insert the stack edge first into the IN drawer until it stops.
ẉ Slide the paper adjusters so that they fit snugly against the edges of the paper
stack.
Ẋ Push the IN drawer back in.
ẋ Print the banner.
You’ll notice that the printer and banner paper go through some start-up
movements before it starts printing. Also, banner printing takes a while; it might
be several minutes before you see the results.
Unattached edge
What If
THE BANNER HAS A BIG
GAP OR A CREASE WHERE
YOU DON’T EXPECT IT
The printer might be
picking up more than
one sheet of paper at a
time. Take the paper out,
then fan the stack. Also
be sure the top and
bottom margins are
set to zero in your
banner program. Print
the banner again.
THE BANNER PAPER
JAMS IN THE PRINTER
❚ You might not have
clicked Banner on the
Setup tab in the
HP print settings box.
❚ Try putting in more
than five, but fewer
than 20, sheets of
paper.
❚ Make sure the banner
switch is up.
❚ See the online
troubleshooting
for the appropriate
settings for specific
software programs.
❚ Make sure you remove
all paper before load-
ing the banner paper.