Filter
Top Products
27. If you need to remove the horizontal bracket from the vertical hinge brackets, remove the two
Phillips PM2.0×5.0 screws (1) that connect the brackets together, and then disconnect the
brackets (2).
NOTE: Steps 28 through 38 provide display assembly internal component removal information
for computers equipped with BrightView display assemblies. See steps 5 through 27 for display
assembly internal component removal information for computers equipped with AntiGlare display
assemblies.
NOTE: See Webcam/microphone moduleon page 49 for webcam/microphone module
replacement instructions for computers equipped with BrightView display assemblies.
28. If it is necessary to replace the display bezel or any of the display assembly internal components,
remove the following screw covers and screws:
(1) Two Mylar screw covers on the display bezel bottom edge. The display rubber screw covers
are included in the Display Rubber Kit, spare part number 512361-001.
(2) Two Phillips PM2.5×6.5 screws.
29. Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge of the
display bezel (3) until the bezel disengages from the display enclosure.
74 Chapter 4 Removal and replacement procedures