Filter
Top Products
d. Display assembly (see Display assembly on page 68).
e. Top cover (see
Top cover on page 80).
f. USB board (see
USB board on page 85).
g. System board (see
System board on page 88).
Remove the power connector cable:
1. Remove the power connector cable (1) from the clips and routing channel (2) built into the base
enclosure.
2. Remove the Phillips PM2.5×7.0 screw (3) that secures the power connector and bracket to the
base enclosure.
3. Remove the power connector bracket (4).
4. Remove the power connector cable assembly (5).
Reverse this procedure to install the power connector cable.
Component replacement procedures 87