Filter
Top Products
6. Remove the hard drive (see Hard drive on page 48).
7. Remove the memory modules (see
Memory modules on page 51).
8. Remove the WLAN module (see
WLAN module on page 52).
9. Remove the optical drive (see
Optical drive on page 55).
10. Remove the base enclosure (see
Base enclosure on page 64).
11. Remove the USB board (see
USB board on page 79).
12. Remove the fingerprint reader module (see
Fingerprint reader board on page 81).
Remove the Leap Motion module:
1. Disconnect the Leap Motion module cable (1) from the system board.
2. Remove the two Phillips PM1.5×2.5 screws (2) that secure the Leap Motion module to the top
cover.
3. Detach the Leap Motion module grounding shield (3) from the top cover. (The Leap Motion
grounding shield is attached to the top cover with double-sided adhesive.)
4. Remove the Leap Motion module (4).
Reverse this procedure to install the Leap Motion module.
Component replacement procedures
83