Filter
Top Products
Message Symptoms and Recommendations
07 RESET
RESETTING [xxx]
Returns all printer settings to Printing Menu settings, and
clears buffered pages, temporary soft fonts, and macros.
Wait for the printer to display the 00 READY message. See
the Reset Menu section in Chapter 3 for more details.
08 NVRAM_INIT Printer is initializing non-volatile RAM. This allows other
personalities to access non-volatile RAM.
08 COLD RESET
RESTORING FACTORY
SETTINGS
Returns both Configuration and Printing Menu selections to
the factory settings. Ensure that the Configuration Menu
settings are correct before placing the printer on-line. Wait
for the printer to display the 00 READY message. See the
Reset Menu section in Chapter 3 for more details.
RESET=MENU
09 MENU RESET
09 RESET ACTIVE I/O
09 RESET ALL I/O
FACTORY DEFAULTS
BEING RESTORED
Follows a Control Panel [Reset] selection. The printer
returns all Printing, PCL, PS, and Job Menu items to the
factory settings. Clears buffered page data, temporary soft
fonts, and temporary macros. See Chapter 3 for more
details.
10 RESET TO SAVE The Printing, PCL, PS, and Config Menus were changed
while data, temporary fonts, or temporary macros were
present in printer memory, or while the printer was in the
middle of a job. Press [Continue]* or [On Line]*. Your
changes remain recorded in the menu but do not become
active until the printer is reset, or the job boundary is
detected.
12 PRINTER OPEN
CLOSE PRINTER COVER
Close the Top Cover Assembly. If the problem continues,
refer to the “12 PRINTER OPEN Message” section.
13 PAPER JAM
REMOVE PAPER JAM
Open printer and clear any paper within the printer. Press
[Continue]* or [On Line]* to reprint the page. If the problem
persists, refer to “13 PAPER JAM Message” section.
13 DUPLEX JAM
REMOVE DUPLEX JAM
Check for any paper in the Duplexer area. If problem
persists, refer to the Duplex Section (Appendix A).
14 NO EP CART
INSTALL TONER
CARTRIDGE
Ensure that the Toner Cartridge is installed correctly (fully
seated into the printer). Try a new Toner Cartridge. If the
problem continues, refer to the “14 NO EP CART Message”
section.
15 ENGINE TEST This message is displayed during the execution of a print
engine self-test. When this test is complete, the printer
returns to the ready state, but remains off line.
16 TONER LOW The toner cartridge is almost empty. Replace the Toner
Cartridge. Although you can continue to print for a short
while, make sure that the print quality does not degrade
past the acceptable level. If the problem continues, refer to
“16 TONER LOW” Message" section.
Table 7-1
Printer Messages (continued)
*
Press Go on the LJ5
.
Troubleshooting 7-3