Filter
Top Products
Testing a SIMM Board
Use the procedures below to print a self-test page to verify SIMM
board installation. Procedures are given for both memory and
PostScript SIMMs.
Memory SIMM
Note
For the LaserJet 5/5M/5N, the On Line key has
been replaced by the Go key. The Enter key has
been replaced by the Select key.
Running a Self Test Printout
1
Plug in the power cord and turn ON the printer.
2
After a few seconds, 00 READY should appear in the control
panel display. If an error message appears, refer to
“Troubleshooting a SIMM Board” later in this chapter.
3 Press [On Line] to take the printer off line.
4 Press [Menu] until TEST MENU appears in the control panel
display.
5 Press [Item] until SELF TEST appears in the control panel
display.
6 Press [Enter] to print a self test.
7 Press [On Line] after the self test printed.
Locate “RAM SIZE” on the self-test printout. This is the amount
of printer memory now installed in the printer.
Configuration 3-57