Filter
Top Products
12. Press the OK button on the front panel. The printer advances the substrate.
13. Assemble a loop-shaping core by matching the shape-coded and color-coded lengths of plastic
tubing. The loop-shaping core must be the same width as the substrate that you are using. Make
sure that both end caps are firmly fitted on the ends of the loop-shaping core.
NOTE: The front-panel display shows the required length of the loop-shaping core based on the
width of the roll that you have loaded into the printer.
14. Gently lower the loading table, to avoid wrinkles and improve winding.
ENWW Use the take-up reel 27
Handle the substrate