Filter
Top Products
Configure IP network settings
View or change network settings
Use the HP Device Toolbox to view or change IP configuration settings.
1. Print a configuration page, and locate the IP address.
●
If you are using IPv4, the IP address contains only digits. It has this format:
xxx.xxx.xxx.xxx
●
If you are using IPv6, the IP address is a hexadecimal combination of characters and digits. It
has a format similar to this:
xxxx::xxxx:xxxx:xxxx:xxxx
2. Open the HP Device Toolbox by clicking the Start button, clicking the Programs or All
Programs group, clicking HP, clicking the product group, and then clicking HP Product
Settings.
3. Click the Networking tab to obtain network information. You can change settings as needed.
Manually configure IPv4 TCP/IP parameters from the control panel
Manually configure IPv4 TCP/IP parameters (LCD control panel)
NOTE: This section applies to the HP LaserJet Pro 200 color M251n Printer model only.
1. On the control panel, press the OK button.
2. Use the arrow buttons to select the Network Setup option, and then press the OK button.
3. Use the arrow buttons to select the TCP/IP configuration option, and then press the OK button.
4. Use the arrow buttons to select the Manual option, and then press the OK button.
5. Use the alphanumeric buttons to type the IP address, and then press the OK button.
6. If the IP address is incorrect, use the arrow buttons to select the No option, and then press the OK
button. Repeat step 5 with the correct IP address, and then repeat step 5 for the subnet mask and
default gateway settings.
Manually configure IPv4 TCP/IP parameters (touchscreen control panel)
NOTE: This section applies to the HP LaserJet Pro 200 color M251nw Printer model only.
Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.
1.
From the Home screen on the product control panel, touch the Setup
button.
2. Scroll to and touch the Network Setup menu.
58 Chapter 4 Manage and maintain the product ENWW