Filter
Top Products
Hardware options installation 20
4.
Press the fan holder release tab, and then remove the fan holder.
5. Remove the bezel blank.
HP recommends that you remove all bezel blanks to facilitate drive installation.
6. Slide the media device part of the way into the bay.
7. Connect the SATA power cable to the media drive.
8. Connect the device cable to the device and the system board or to an expansion board, as directed by
the option documentation.
9. Slide the media drive fully into the bay until it is seated securely.
10. Install the fan holder.
11. Install the access panel.
12. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.