Filter
Top Products
Introduction
About this guide
About this guide
This guide explains how to work with the Command Line Interface (CLI) on HP ProCurve
Networking MSM3xx and MSM4xx APs.
Products covered
This guide covers the following products:
Model
Part number
USA
version
Worldwide
version
MSM310 Access Point J9374A J9379A
MSM310-R Access Point J9380A J9383A
MSM320 Access Point J9360A J9364A
MSM320-R Access Point J9365A J9368A
MSM325 Access Point with Sensor J9369A J9373A
MSM335 Access Point with Sensor J9356A J9357A
MSM410 Access Point J9426A J9427A
MSM422 Access Point J9358A J9359A
HP ProCurve Product Naming
As of October 1st, 2008, Colubris Networks was acquired by HP ProCurve. HP ProCurve has
begun integrating the Colubris product line into the HP ProCurve Networking product
portfolio (www.procurve.com/news/colubris-10-01-08.htm).
In the online help and this manual, Colubris product names have been changed to their
equivalent HP ProCurve product names.
Note SOAP and SNMP MIBs retain the Colubris naming so you do not need to change your existing
SOAP and MIB usage.
The Colubris Networks product names and their corresponding new HP ProCurve product
names are as follows:
Colubris name HP ProCurve name
MSC-5100 MultiService Controller MSM710 Controller
MSC-5200 MultiService Controller MSM730 Controller
MSC-5500 MultiService Controller MSM750 Controller
1-2