Filter
Top Products
CLI commands
This is a global setting that is useful when creating wireless links to remote sites. However, it also
applies to all wireless connection made with the radio, not just for wireless links. Therefore, if you
are also using the radio to serve local wireless client stations, adjusting this setting may lower the
performance for clients with marginal signal strength or when interference is present.
(Essentially, it means that if a frame needs to be retransmitted it will take longer before the actual
retransmit takes place.)
dot11 mode
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
dot11 mode (monitor | ap+wds | ap-only | wds-only | sensor)
Sets the operating mode for the radio.
spectralink view
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
spectralink view
Enable the use of spectralink view.
no spectralink view
Disable the use of spectralink view.
dot11n channel extension
Supported on: MSM410 MSM422
dot11n channel extension (above | below)
Select the 802.11n channel extension. Applicable only in the 2.4 GHz band with a 40 MHz channel
width.
dot11n channel width
Supported on: MSM410 MSM422
dot11n channel width (40 | 20 | auto)
Select the 802.11n channel width.
dot11n guard interval
Supported on: MSM410 MSM422
dot11n guard interval (short | long)
Select the 802.11n guard interval.
dot11n multicast rate
Supported on: MSM410 MSM422
dot11n multicast rate <rate>
Set the multicast rate for use with 802.11n networks.
2-52