HP (Hewlett-Packard) MSM3XX Switch User Manual


 
CLI commands
delete ip filter
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
delete ip filter <ip address>/<mask>
Deletes the specified address from the IP filter list.
If the list is empty, then all wireless-to-wired LAN traffic is permitted.
Where:
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of bits in the mask.
delete ip filter all
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
delete ip filter all
Deletes all addresses from the IP filter list.
ip filters
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
ip filters
Activates the IP filter which enables you to block wireless-to-wired LAN traffic on this profile
based on its destination address.
no ip filters
Disables the IP filter for this profile.
active
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
active
Enable this VAP (VSC).
no active
Disable this VAP (VSC).
beacon dtim count
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
beacon dtim count <number>
Defines the DTIM period in the beacon.
Client stations use the DTIM to wake up from low-power mode to receive multicast traffic. The AP
transmits a beacon every 100 ms. The DTIM counts down with each beacon that is sent, therefore
if the DTIM is set to 5, then client stations in low-power mode will wake up every 500 ms (.5
second) to receive multicast traffic.
2-62