Filter
Top Products
Introduction
Configuring CLI support
Configuring CLI support
Using the AP management tool, open the page Management > CLI. Use this page to enable/
disable CLI support via an SSH or serial connection. A maximum of three concurrent CLI
sessions are supported regardless of the connection type.
The CLI supports SSH on the standard TCP port (22).
Connectivity and login credentials for SSH connections use the same settings as defined for
the management tool manager on the Management > Management tool page.
SSH connections to the CLI can be made on any active interface. Support for each
interface must be explicitly enabled under Security.
The login credentials for SSH connections are the same as those defined under Manager
account. By default, both username and password are set to admin.
Note SSH logins always use the local manager username and password, even if Administrative
user authentication is set to use a RADIUS server.
1-6