Filter
Top Products
Preface
3
Precautions
Follow the procedures listed below to ensure safe handling of components and to
prevent harm to yourself and the NetServer.
WARNING The HP NetServer LH 3r weighs up to 160 pounds (73 kg.)
when fully loaded. If you are removing the LH 3r from the
rack, remove the power supplies and hard disk drives before
doing so. Follow all local regulations when lifting the
NetServer.
To prevent the rack enclosure from tipping over,
•
Extend the anti-tip foot on the rack
•
Verify that the leveling feet on the rack are lowered
•
Do not extend more than one piece of equipment at once
Before removing the cover, always disconnect the power cord
and unplug telephone cables. Disconnect the power cord to
avoid exposure to high energy levels that may cause burns
when parts are short-circuited by metal objects, such as tools
or jewelry. Disconnect telephone cables to avoid exposure to
shock hazard from telephone ringing devices.
Note that the power switch does not turn off the standby
power. Disconnect the power cord to turn off standby power.
If the backlight on the LCD display is on, standby power is
still on.
CAUTION Never operate this NetServer without first installing all covers
and the front bezel. Operating the system without all covers in
place reduces critical cooling airflow over some components,
such as hard disk drives and processor modules. Operating the
system without all covers in place may result in failure of these
components.
Wear a wrist strap and use a static-dissipating work surface
connected to the chassis at all times to prevent possible static
electricity damage to the NetServer components.