Filter
Top Products
4 Switch Interface Administration Digital Interfaces
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 155
8 Enter the type of addressing to be used with outgoing calls, either DTMF,
MF, or DECADIC in the
Outgoing Addressing Type: field. The default
is DTMF.
9 Enter the type of addressing to be used with incoming calls, either DTMF,
MF, or DECADIC in the
Incoming Addressing Type: field. The default
is DTMF.
10 Enter the type of signaling to be used with outgoing calls, either Wink or
Immediate in the
Outgoing Signaling Type: field. The default is
Wink.
11 Enter the type of signaling to be used with incoming calls, either Wink or
Immediate in the
Incoming Signaling Type: field. The default is
Wink.
12 Enter the volume adjustment for all incoming speech on circuit cards in
the
Incoming Speech Volume: field. Valid values are 0 to 32000. Note
that values less than 100 or greater than 8000 may distort the incoming
speech. The default is 1414.
Any adjustment occurs before the system processes the incoming speech
for coding it later for playback. The value in the
Incoming Speech
Volume:
field represents a gain applied to the speech input using a
logarithmic scale. A value of 1000 equals no gain; that is, the input is
coded at the same level as it is received. Multiplying by 1.414 (the square
root of 2) approximately doubles the input volume, or increases it by 3 dB.
Therefore, a value of 1414 in the field doubles the volume of incoming