Filter
Top Products
A Summary of Commands restore
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 560
a port of card#. If port# is not given, all ports of the card specified are
restored. If no card number or channel number is given, the system
displays a syntax message.
• -n — Disables prompting from the system, whether to wait until a conflict
has been resolved (see the -i option below) or to terminate the request to
restore.
• -i — Enables secondary command registration. If T1 diagnostics are
being run, this option allows “restoring” of another card to be performed.
If -i is used and another maintenance command is being run (remove,
detach, attach, restore, diagnose), the request to restore card is
blocked and a message is printed to the screen. If -i is not used and any
maintenance command is being run, the request to restore card is
blocked and a message is printed to the screen.
If the command is permitted to run, a check is made to see if the
command is in conflict with another. A command is in conflict if the card
or card associated with it:
~ Is the T1 card being diagnosed
~ Will cause a change in the existing TDM bus master assignment
~ Has an interdependency with the T1 card being diagnosed (for
example, PRI)
If one of the above conflicts exist and -n is not used, the user is asked
whether to wait until the conflict is resolved or to terminate the request. If