Filter
Top Products
A Summary of Commands attach
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 383
• -n — This option disables prompting from the system whether to wait until
a conflict has been resolved (see the -i option below) or to terminate the
request to attach.
• -i — This option is used to enable secondary command registration. If T1
diagnostics are being run, this option allows the “attaching” of another
card. If -i is used and another maintenance command is being run
(remove, detach, attach, restore, or diagnose), the request to attach is
blocked and a message is printed to the screen. If -i is not used and any
maintenance command is being run, the request to attach is blocked and
a message is printed to the screen.
If the command is permitted to run, it is determined if the command is in
conflict with another command. A command is in conflict if the card or
card associated with the command meets any of the following conditions:
~ T1 card is being diagnosed
~ An interdependency exists with the T1 card being diagnosed (for
example, PRI)
If one of the above conflicts exist and -n is not used, the user is asked
whether to wait until the conflict is resolved or to terminate the request. If
T1 diagnostics are executing online tests and a conflict is detected, the
attach command is blocked. If T1 diagnostics are executing offline tests
and a conflict is detected, the user is asked whether to wait until the
conflict is resolved or to terminate the request to attach.