Filter
Top Products
A Summary of Commands wl_gen
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 623
• /vs/pack/cmp.seg.sw — Vocabulary and model information for
companion card DSPs
• vs/pack/resource.sw — Wordlist resource information for the resource
manager
The wl_gen command should be called whenever there is a change to an
active wordlist or when a wordlist is activated or deactivated. You need to
diagnose the FlexWord SSP circuit card after using the wl_gen command.
The [-L language] argument is used to specify the language output that
appears on the screen, that is, Brazilian, English, French, German,
Japanese, or Spanish.
If more than 38 phonemes, including the underscore (_), are found with any
word or phrase within a wordlist by the wl_gen command, you receive an
error message. Once wl_gen finds an error within a wordlist, it quits looking
at that wordlist, and the wordlist containing that word or phrase is not used
when generating the FlexWord data files. Therefore, if you receive an error,
you might have to run wl_gen several times to iteratively locate each error.
An example of the error message you will receive regarding the filename
ACCT_NUM is as follows:
Generating the FlexWord data files ...
‘ACCT_NUM’ ignored: it contains a word with more than 38
phonemes
(Six_Six_Six_Six_Six_Six_Six_Six_Six_)