Filter
Top Products
43
Rebooting the System
Reboot a System with a Single Controller
Enter the CLI
reload
command in privileged EXEC mode. The system prompts for you to verify the
reload. If you had not already saved configuration changes, and the system detects the changes, it
prompts you to save. If you enter yes, the new configuration is stored in startup-config. You may
optionally save the configuration to an alternate file by entering the file name, followed by a
carriage-return.
Example
The system re-initializes itself and then loads the system-image and the startup-config file. Wait a few
minutes and attempt to log onto the chassis.
Topspin-360> enable
Topspin-360# reload
System configuration has been modified. Save?
[yes(default)/no/*.cfg] yes
Proceed with reload? [confirm]
Topspin-360#
Connection to host lost.