Filter
Top Products
Media
Supply
Window
Media
Supply Door
Printhead
Latch
Hinge
Plate
Media
Guide
Loading Media
6 Operator’
s Guide
The printer accepts a wide range of media. It
can be loaded with roll–fed, fan–folded, or
die–cut continuous media of either thermal
transfer or direct thermal type. Media width
can range from 0.75 inches (19.1 mm) to
4.65 inches (118.1 mm). Media thickness
can range from 0.0025 inches (0.0635 mm)
to 0.01 inches (0.254 mm).
Use the following procedures to load media
of various kinds into the printer.
1 Press ON LINE/PAUSE to place the
printer in the of
f line mode.
Open the media supply door.
2 Rotate the printhead latch
counterclockwise to unlatch, and raise
the printhead to an upright position.
3 Lower the hinge plate down. Slide the
media guide to the outer edge, and
rotate it to the down position.
4 If you are loading fan–folded
media,
skip the next step and go on to step 6.
5 T
o load
roll–fed media, continue as
follows: