Filter
Top Products
Printhead
Latch
Hinge
Plate
installing the ribbon
19Operator’
s Guide
7 Raise the J-hook upward, and place the
end of the ribbon over the take-up hub.
8 Slide the J-hook back into place, as
shown. While holding the ribbon take-up
hub, rotate the J-hook counterclockwise
to latch.
T
urn the take-up hub until all the ribbon
slack is removed.
9 Raise the hinge plate, and lock the
printhead by rotating the printhead latch
clockwise.
10 Close the media supply door.
11 Press ON LINE/PAUSE
to enable
printing.
J-Hook
Take-Up Hub
Ribbon