Filter
Top Products
Media
Supply
Window
Media
Supply Door
Printhead
Latch
Hinge
Plate
Media
Guide
Unloading Media
14 Operator’
s Guide
Use the following procedure to unload media
from the printer.
1 Press ON LINE/PAUSE to place the
printer in the of
f line mode.
Open the media supply door.
2 Rotate the printhead latch
counterclockwise to unlatch, and raise
the printhead to an upright position.
3 Lower the hinge plate down. Slide the
media guide to the outer edge, and
rotate it to the down position.
4 Cut the media either before or after the
front slot, depending on whether or not
the rewind hub is being used.
note
If
the media rewind hub was being used,
you may choose to continue winding the
media onto the hub or to roll it back onto
the supply roll (media hub).
5 If the installed media is fan–folded,
skip
the next step and go on to step 7
.
Otherwise, continue with step 6
.