Filter
Top Products
Printhead
Latch
Hinge
Plate
Media
Guide
loading media
9Operator’
s Guide
10 If the media you are loading is of the
same width
as the current media, skip
the next step and go on to step 12
.
11 If you are loading media that is of a
different
width from the current media,
you may need to adjust print quality as
follows:
note
The
printer is aligned at the factory with
4–mil–thick label stock, whose width is
the maximum width accepted by the
printer.
a. Raise
the hinge plate, and lower the
printhead by rotating the printhead
latch clockwise to the latched
position.
b. Press ON LINE/PAUSE
to enable
printing.
c. Send a sample test print file from the
host, or run the internal diagnostic
test file.
note
It
may be necessary to feed several
labels before proper alignment of the
media occurs.
d. If the print quality is acceptable, go
on to
step 12.
e. Otherwise, press ON LINE/PAUSE
again to place the printer in the of
f
line mode.
note
Although
the head leveling knob can be
adjusted during printing, it is
recommended that this adjustment be
done while the printer is paused.