Filter
Top Products
AC
Power
Connector
Fuse
Holder
AC Power
Switch
Message
Display
Primary
Control
Panel
Message
Display
Contrast
Adjust
Secondary
Control
Panel
Powering On the Printer
1Operator’
s Guide
caution
Before powering on the printer
, make
sure it is plugged into the appropriate
power source.
Refer to the “Select a Site” section in
Chapter 2 of the
Setup Guide
for
information on proper power sources.
The power switch is located on the lower
right–hand corner of the rear of the printer
. It
is marked f for power OFF and | for power
ON.
For help with diagnosing printer problems,
printer self–test routines are automatically
run during the power–on cycle. Further
diagnostic tests can be performed using the
secondary operator panel functions. They
are covered in detail in the
Setup Guide
.
Using the Primary Operator Panel
Use the primary operator panel to perform
routine operations. The panel contains three
operator-accessible keys and three indicator
lights, used to control and indicate printer
status.
note
The
functions and meanings of some of the
keys and indicators on the primary operator
panel will change depending on the
firmware installed. This manual describes
printer operation with Printronix LP+,
IGP/PGL or IGP/VGL emulation firmware
installed. If your printer has Printronix
IGP/FGL emulation firmware, please refer
to the
T3306 and T3308 Label Printers
Operator’
s Guide
, p/n 136452–001.
There is also a
secondary
operator panel,
consisting of a message display and six
keys. This panel is used to configure the
printer and to run self–tests, via the
configuration menus.