Filter
Top Products
Chapter 3 Using the Operator Panel
3-17
Changing the Maximum Number of Quick Copy/Proof-and-
Hold Jobs
This changes maximum number of Quick Copy/Proof-and-
Hold jobs from 0 to 50. The default is 32.
Press the MENU key.
Press the or key repeatedly until e-MPS > ap-
pears.
Press the key.
Press the or key repeatedly until >e-MPS
Configuration > appears.
Press the key.
Press the or key repeatedly until >>Quick
Copy appears.
Press the ENTER key. A blinking cursor (_) appears.
Press the or key to increase or decrease the val-
ue at the blinking cursor. The value can be set be-
tween 0 and 50. Use the and keys to move the
cursor right and left.
When the desired maximum number of jobs is set,
press the ENTER key.
Press the MENU key. The display returns to Ready.
Maximum Space Assigned to Temporary Code Jobs
This changes the hard disk space that holds temporary code
jobs. You can change the maximum space from 0 to 9999
(megabytes). The actual maximum size depends on the size
of free hard disk space, however. The default size is 1/6 of the
total hard disk space, rounded off in units of 50 MB. For ex-
ample, if the total hard disk space is 3.2 GB, the default size
is 500 MB.
Press the MENU key.
Press the or key repeatedly until e-MPS > ap-
pears.
Press the key.
Press the or key repeatedly until >e-MPS
Configuration > appears.
Press the key.
Press the or key repeatedly until >>Temp. Code
JOB Size appears.
To change the maximum disk space, press the EN-
TER key. A blinking cursor (_) appears.
Press the or key to increase or decrease, respec-
tively, the value at the blinking cursor. Use the
and keys to move the cursor right and left.
When the desired size is displayed, press the ENTER
key.
Press the MENU key. The display returns to Ready.
e-MPS >
>e-MPS >
Configuration
>>Quick Copy
32
>>Quick Copy
32
1
2
3
4
5
6
7
8
9
10
e-MPS >
>e-MPS >
Configuration
>>Temp. Code JOB
Size 0500MB
>>Temp. Code JOB
Size 050
0MB
1
2
3
4
5
6
7
8
9
10