Filter
Top Products
Chapter 3 Using the Operator Panel
3-53
Press the ENTER key. A blinking cursor (_) appears.
Press the or key to increase or decrease the val-
ue of the figure where the cursor is blinking and set
the desired time. The time must be set between 000
and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without
allowing any time interval. You can use the and
keys to move the cursor right and left.
Display the desired time and press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Finishing
These settings are possible only when the optional finisher is
installed on the printer.
Duplex Printing Error Detection Setting
This setting controls whether or not the message
Duplex
disabled Press GO
appears when label or some other type
of paper that is not supported for duplex printing is specified
as the paper type when duplex printing is being performed.
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >Finishing
Error > appears.
Press the key.
Press the or key repeatedly until >>Duplex
appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key to change Off to On.
Press the ENTER key.
To exit the menu selection, press the MENU key.
Staple Error Detection Setting
This setting controls whether or not message Add staples
appears when the finisher units runs out of staples during
output of a stabled job.
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >
Finishing Error > appears.
Press the key.
>>Auto Continue
Timer 030
Sec.
On
• Press the
GO
key to perform simple printing.
• Press the CANCEL key to cancel the print job.
Off
Disable duplex printing. (reverts to simplex
printing)
Others >
>Finishing >
Error
6
7
8
9
1
2
3
4
5
>>Duplex
OFF
>>Duplex
? Off
On
Message is displayed and printing pauses.
Printing resumes automatically when staples
are replenished.
Off
Message is displayed, but printing continues
without stapling.
Others >
>Finishing >
Error
6
7
8
9
10
1
2
3
4
5